Filter
Top Products
118 Enabling DHCP on the HP N1200-320 4Gb Network Storage Router
Setting up DHCP over network storage router interfaces
Network storage routers use three different interfaces which can be used to enable DHCP: Serial, Telnet,
and VM. The following will describe how to enable and disable DHCP for each interface.
NOTE: Located on the network storage router is a label that displays the unit’s Ethernet MAC Address. A
network administrator can then use this MAC Address to set up a lease reservation on the DHCP server for
the IP address of the network storage router. This effectively allows the network storage router to have a
permanent IP address that is assigned by the DHCP server.
Serial and Telnet interfaces
When the user turns on the library, and thus the network storage router, the system reboots and displays
the following Main menu on the terminal window:
Figure 77 Main menu
• Select 1. The following menu appears:
Figure 78 Configuration menu
HP StorageWorks N1200-320 4Gb network storage router
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
07/7/2005 08:56:22
1) Perform Configuration
2) System Utilities
3) Display Trace and Assertion History
4) Reboot
5) Download a New Revision of The Firmware
Copyright (C) 1998 - 2004 Crossroads Systems, Inc. All rights reserved.
Command >
Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
07/7/2005 08:56:22
1) Baud Rate Configuration
2) Ethernet Configuration
3) Fibre Channel Configuration
4) Parallel SCSI Configuration
5) Device Mapping
6) Trace and Event Settings Configuration
7) Real-Time Clock Configuration
8) Active Fabric Configuration
A) Save Configuration
B) Restore Last Saved Configuration
C) Reset to Factory Defaults
X) Return to main menu