Filter
Top Products
N1200-320 4Gb Network Storage Router user and service guide 119
• Select 2. The following menu appears:
Figure 79 Ethernet configuration menu
Select 7 to toggle the DHCP setting. When DHCP is enabled, this activates Dynamic Host Configuration
Protocol and allows the network storage router to be assigned a dynamic IP address from a DHCP server
located on the Ethernet network used by the network storage router.
For descriptions of other menu selections, refer to ”N1200-320 4Gb Network Storage Router
management”.
Once DHCP is enabled, it is necessary to save the current configuration and reboot the network storage
router before DHCP will operate.
NOTE: For the IP address, Subnet Mask, and IP Gateway address, it is okay to have null values prior to
rebooting the network storage router. However, if these settings have null values after a reboot, then this
indicates the DHCP Server was unable to acquire the information for that setting. See the note below for
more information.
Use the following steps to save the current settings and reboot the system:
1. Select X) Return to previous menu.
2. Select A) Save Configuration.
3. Select X) Return to previous menu.
4. Select 4) Reboot.
After the network storage router finishes rebooting, the Main Menu will appear. DHCP status can be
verified from the Ethernet Configuration Menu where DHCP Configuration is indicated as “Enabled” if
Ethernet Configuration Menu
X.X.XX XXXXXX XXXXXX-XXX_XXXXXXXXXXXXXX
07/7/2005 08:56:22
IP Address : 1.1.1.1
Subnet Mask : 255.255.255.0
IP Gateway : 0.0.0.0
Ethernet Physical Address : 08:06:07:05:03:09
Ethernet Mode : 10/100Mbps (Auto-Neg)
Hostname :
DHCP Configuration : Disabled
1) Change IP Address
2) Change IP Subnet Mask
3) Change IP Gateway
4) Change Ethernet Physical Address
5) Toggle Ethernet Mode
6) Change Hostname
7) Toggle DHCP Configuration
8) Change Security Settings
X) Return to previous menu