Filter
Top Products
VA 7100/7400 Cluster Installation Guide
10/12/01 37
15. In the Completing the Create Partition Wizard window that appears as shown below, review the entered
selections to verify accuracy. If required, click Back and make corrections as necessary. Then, click Finish to
create and format the Content partition.
NOTE The formatting time will vary with the Content partition size being created.
NOTE The following step is necessary for configuration of the dedicated Ethernet interconnect (private)
network (refer to step 2 of this procedure). Refer to Microsoft Knowledge Base article Q242430
for more information.
16. At this time, turn on node 2 power and strike the Pause key on the keyboard when the controller begins
initiating. Leave node 2 in the Pause state.
NOTE Do not perform any further node 2 operations until specifically instructed in chapter 7 because both
nodes cannot simultaneously access the external storage array before cluster service has been
installed, configured, and is up and running.
17. Continue with node 1 configuration by proceeding to Chapter 6, Cluster Setup.