Filter
Top Products
3 - 7
Default = External or Interface Cable Power.
Paging
Paging Mode
By default, the paging button on the base or Access Point pages the scanners associated with that base or Access Point. If
you want the paging button on your base or Access Point to be disabled, scan the Paging Mode Off bar code, below.
When Paging Mode is off, the base or Access Point will no longer page scanners when the button is pressed. The red LED
on the base or blue LED on the Access Point will remain lit to indicate that Paging Mode is off. (This light will go out when
the button is pressed, then back on when it’s released.) Default = Paging Mode On.
Paging Pitch
When you press the Page button on the base or Access Point, the scanners associated with that base or Access Point will
begin beeping (see Page Button on page 3-3). You can set the pitch of the paging beep for each scanner by scanning one
of the following bar codes. Default = Low.
Base Charge Off
External or Interface Cable
Power
External Power Only
* Paging Mode On
Paging Mode Off
* Low (1000 Hz)
Medium (3250 Hz)