Filter
Top Products
3 - 8
Error Indicators
Beeper Pitch - Base Error
The CCB01-010BT base can be configured to beep at a particular pitch when an error occurs, such as transmission prob-
lems to a host system. The beeper pitch codes modify the pitch (frequency) of the error tone the base emits when there is
an error. Default = Low.
Number of Beeps - Base Error
The number of beeps and LED flashes emitted by the CCB01-010BT base for an error condition can be programmed from
1 - 9. For example, if you program this option to have five error beeps, there will be five error beeps and five LED flashes in
response to an error. To change the number of error beeps, scan the bar code below and then scan a digit (1-9) bar code
and the Save bar code on the Programming Chart inside the back cover of this manual. Default = 1.
Scanner Report
Scan the bar code below to generate a report for the connected scanners. The report indicates the port, work group, scanner
name, and address. To assign a name to your scanner, refer to Menu Command Syntax, page 10-1.
High (4200 Hz)
* Razz (250 Hz)
Medium (3250 Hz)
High (4200 Hz)
Number of Base Error Beeps/LED Flashes
Scanner Report