Filter
Top Products
11 - 2
Important! The following cleaning solutions have been tested to assure
safe cleaning of your scanner’s disinfectant-ready housing. They are the
only solutions approved for use with these scanners. Damage caused by
the use of cleaners other than those listed below may not be covered by
the warranty.
• Sani-Cloth
®
HB wipes
• Sani-Cloth
®
Plus wipes
• Super Sani-Cloth
®
wipes
• Isopropyl Alcohol wipes (70%)
•CaviWipes
™
•Virex
®
256
•409
®
Glass and Surface Cleaner
•Windex
®
Blue
•Clorox
®
Bleach – 10%
• Gentle dish soap and water
Inspecting Cords and Connectors
Inspect the interface cable and connector for wear or other signs of dam-
age. A badly worn cable or damaged connector may interfere with scanner
operation. Contact your distributor for information about cable replace-
ment. Cable replacement instructions are on page 11-2.
Replacing Cables in Corded Scanners
The standard interface cable is attached to the scanner with an 10-pin modular
connector. When properly seated, the connector is held in the scanner’s handle
by a flexible retention tab. The interface cable is designed to be field replace-
able.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the
original interface cable.