Filter
Top Products
13 - 1
13
Maintenance
Repairs
Repairs and/or upgrades are not to be performed on this product. These services are to be performed only by an authorized
service center (see Customer Support on page 14-1).
Maintenance
Your device provides reliable and efficient operation with a minimum of care. Although specific maintenance is not required, the
following periodic checks ensure dependable operation:
Cleaning the Scanner
The scanner’s housing may be cleaned with a soft cloth or tissue dampened with water (or a mild detergent-water solution.)
If a detergent solution is used, rinse with a clean tissue dampened with water only.
Cleaning the Window
Reading performance may degrade if the scanner’s window is not clean. If the window is visibly dirty, or if the scanner isn’t
operating well, clean the window with one of the cleaning solutions listed below.
• Sani-Cloth
®
HB wipes
• Sani-Cloth
®
Plus wipes
• Super Sani-Cloth
®
wipes
• Isopropyl Alcohol wipes (70%)
• CaviWipes
™
•Virex
®
256
•409
®
Glass and Surface Cleaner
• Windex
®
Blue
•Clorox
®
Bleach – 10%
• Gentle dish soap and water
Inspecting Cords and Connectors
Inspect the interface cable and connector for wear or other signs of damage. A badly worn cable or damaged connector
may interfere with scanner operation. Contact your distributor for information about cable replacement. Cable replacement
instructions are on page 13-1.
Replacing Cables
The standard interface cable is attached to the scanner with an 15-pin modular connector. The interface cable is designed to be
field replaceable.
• Order replacement cables from Honeywell or from an authorized distributor.
• When ordering a replacement cable, specify the cable part number of the original interface cable.
Do not submerge the scanner in water. The scanner’s
housing is not watertight.
Do not use abrasive wipes or tissues on the scanner’s
window – abrasive wipes may scratch the window. Never
use solvents (e.g., acetone) on the housing or window –
solvents may damage the finish or the window.
!
Caution:
Do not submerge the scanner in water. The scanner’s
housing is not watertight.
Do not use abrasive wipes or tissues on the scanner’s
window – abrasive wipes may scratch the window. Never
use solvents (e.g., acetone) on the housing or window –
solvents may damage the finish or the window.