Filter
Top Products
3 - 10
Mobile Phone Read Mode
When this mode is selected, your scanner is optimized to read bar codes from mobile phone or other LED displays. However,
the speed of scanning printed bar codes may be slightly lower when this mode is enabled. You can enable Mobile Phone Read-
ing for either a hand held device, or for a hands-free (presentation) application.
Note: To turn off Mobile Phone Read Mode, scan a Manual or Serial Trigger Mode bar code (see page 3-5).
Hands-Free Time-Out
The Presentation Mode is referred to as “hands-free” mode. If the scanner’s button is pressed when using a hands-free mode,
the scanner changes to manual trigger mode. You can set the time the scanner should remain in manual trigger mode by set-
ting the Hands-Free Time-Out. Once the time-out value is reached, (if there have been no further button presses) the scanner
reverts to the original hands-free mode.
Scan the Hands-Free Time-Out bar code, then scan the time-out duration (from 0-300,000 milliseconds) from the inside back
cover, and Save. Default = 5,000 ms.
Character Activation Mode
You may use a character sent from the host to trigger the scanner to begin scanning. When the activation character is received,
the scanner continues scanning until either the Character Activation Laser Timeout (page 3-11), the deactivation character is
received (see Deactivation Character on page 3-12), or a bar code is transmitted. Scan the following On bar code to use char-
acter activation, then use Activation Character (following) to select the character you will send from the host to start scanning.
Default = Off.
Hand Held Scanning - Mobile
Phone
Streaming Presentation -
Mobile Phone
Hands-Free Time-Out
* Off
On