Filter
Top Products
Corrective actionExplanationState nameState code
Transient – No action is necessary.Modem is in boot phase. Downlink
has been established; that is, beacon
Downlink Established in
Boot
7
is being tracked and transmission
information packets are being
received.
Transient – No action is necessary.Modem is in boot phase and is waiting
for indirect and direct management
packets.
Waiting for MIPs in Boot8
Transient – No action is necessary.Modem is in boot phase and is
downloading commissioning software.
Downloading
Commissioning Software
9
Installer must complete validation.Modem is waiting for antenna
pointing validation to complete.
Occurs during installation only.
Waiting for Antenna
Pointing Complete
10
Installation – Commissioning phase
Transient – No action is necessary.Modem is starting up in
commissioning phase.
Starting Up in
Commissioning
11
Transient – No action is necessary.Modem is in commissioning phase.
Downlink has been established; that
Downlink Established in
Commissioning
12
is, beacon is being tracked and
transmission information packets are
being received.
Transient – No action is necessary.Modem is in commissioning phase
and is waiting for indirect and direct
management packets.
Waiting for MIPs in
Commissioning
13
Transient – No action is necessary.Modem is in commissioning phase.
Probing is in progress. Occurs during
installation only.
Probing in Progress14
Occurs only during installation.
Modem is in commissioning phase.
Probing has failed.
Probing Failure15
Transient – No action is necessary.Modem is in commissioning phase.
Modem is registering with the NOCC.
Registering ST16
Occurs only during installation.
Modem is in commissioning phase:
registration with the NOCC has failed.
ST Registration Failure17
Transient – No action is necessary.Modem is in commissioning phase;
modem is waiting for capacity keys
from the NOCC.
Waiting for Capacity
Keys
18
Transient – No action is necessary.Modem is in commissioning phase;
modem is reconciling proles with the
NOCC.
Reconciling Proles in
Commissioning
19
Transient – No action is necessary.Modem is in commissioning phase
and is downloading operational
software.
Downloading Operational
Software
20
Note: State codes 1 – 20 appear only while the modem is being installed or during a hard reboot (resulting from power
being removed and then restored).
21
Chapter 2HN9000 Satellite Modem User Guide –
1037577-0001 Rev. A
System Control Center