Filter
Top Products
Corrective actionExplanationState nameState code
Operational phase
Transient – No action is necessary.Modem is starting up in operational
phase.
Starting Up in Operation21
Transient – No action is necessary.Modem is in operational phase.
Downlink has been established; that
Downlink Established in
Operational
22
is, beacon is being tracked and
transmission information packets are
being received.
Transient – No action is necessary.Modem is in operational phase and is
waiting for indirect and direct
management packets.
Waiting for MIPs in
Operational
23
Transient – No action is necessary.Modem is in operational phase.
Proles are being distributed to
various subsystems.
Reconciling Prole in
Operational
24
Steady state – No action is necessary.Modem is fully operational.Fully Operational (normal
operation)
25
Error codes
Make sure the SAT. IN and SAT.
OUT cable connections are nger
Rx cable connectivity tests have
failed.
Rx Connectivity Down26
tight. If the problem persists, call your
service provider to verify cabling and
pointing.
Call your service provider to verify
cabling and pointing.
Modem is unable to track beacon.No Beacon27
Call your service provider to verify
cabling and pointing.
Modem is not receiving transmission
information packets from satellite.
No TIPs28
Call your service provider to verify
cabling and pointing.
Tx cable connectivity tests have failed.Tx Connectivity Down29
Rain or snow can cause this condition.
If it continues during clear weather,
Bad slots are transmissions from the
modem that are not received by the
Too Many Bad Slots30
call your service provider to verify
cabling and pointing.
satellite. State code 30 indicates a
percentage of bad slots within the last
hour that exceeds a preset value.
Transient – No action is necessary.
Transmitter has been shut down due
to ECL. ECL measures total
ECL Active31
Because home installations use lower
wattage radios, home users are not
likely to see this condition.
transmitted power over 30- minute
periods and turns off the transmitter
if the total power exceeds a preset
limit imposed by the FCC.
Restricted states (NOCC-imposed restrictions)
Call your service provider.Modem has been barred from
transmitting by the NOCC. Possible
Barred32
reasons for barring include
interference isolation, uplink failure,
or government order.
22
System Control CenterHN9000 Satellite Modem User Guide –
1037577-0001 Rev. A
Chapter 2