Filter
Top Products
Chapter 2: Macintosh Installation
This chapter describes how you can use your scanner with your Macintosh computer.
Interface Card Installation (For Mac with built in SCSI port users, please skip to next section)
Before you can use your scanner with your computer, you need to install the interface card into
your Computer.
To install the card into one of the computer’s expansion slots, observe the following procedures:
Note: The interface card is sensitive to static electricity. Handle the card by its mounting bracket,
particularly when removing the card from its anti-static packaging.
1. Turn the computer power off and unplug the power cord.
2. Remove the housing cover of the computer. Follow the instructions provided in your
Computer’s reference manual.
3. Remove the metal cover corresponding to your chosen slot. Keep the removed screw so that
it can be used to fasten the interface card.
4. Gently insert the interface card into the slot until it is firmly seated in the slot.
5. Secure the card in place with the screw removed from the expansion slot cover in step 3
above.
6. Replace the housing cover following the instructions provided in the computer’s reference
manual.
Connect the Scanner to your Computer
1. Ensure that the scanner’s SCSI ID is properly set. Refer to the “Changing the SCSI ID
Number” section in Chapter 1 for instructions on setting the scanner’s SCSI ID.
2. Turn on Active terminator and termination power (please refer to Appendix A for more
details on setting termination), connect the SCSI cable to SCSI port and connect the other end
of he SCSI cable to the scanner.
10