Filter
Top Products
Quick Start Guide
This section serves as a quick reference to the connection and installation procedures for the
PowerLook 2100XL scanner.
1. Unpack your Scanner
Unpack your scanner. Make sure that all the scanner system hardware, software, cabling, and
documentation items indicated on the packing list are present.
2. Connect the Interface Card
a) For PC users, turn off your computer and remove the computer’s housing cover.
b) For New Power Mac G3 and G4 users, turn off your computer and open the side lid of your
computer.
c) Locate an available slot.
d) Insert the SCSI card by pressing it gently but firmly into the slot. Make sure it is firmly
seated in the slot and firmly tighten the screw (as shown in the figures below).
For PC Users For New Power Mac G3, G4 users
3. Connect the SCSI Cable
Connect the SCSI cable to the SCSI interface card and the other end of the SCSI cable to the
scanner. For stable SCSI connection, setting terminator is required. Please refer to Appendix A
for more details on setting termination.
4. Connect the Power
Connect the power cord to the scanner and plug the other end of the power cord into an available
outlet (socket).
3