Filter
Top Products
Test Cases for DB2 Recovery Data Sets 187
Figure 120. Management Class Routine Extract for BSDS and Active Logs
B.1.3 Storage Group
Storage Group SGDB2PLG was defined for use by the BSDS and active log data
sets of the DB2P subsystem. Five disk volumes were defined to this Storage
Group: RV1CU1, RV2CU1 and RV3CU1 for the active logs; and RV2CU3 and
RV3CU3 for the BSDS’s.
Storage Group SGDBACTL was defined for use by the BSDS and active log data
sets of the DB2D and DB2T subsystems. Two disk volumes were defined to this
storage group: RV1CU3 and RV2CU2.
A disk volume summary is shown in Table 32 on page 187.
Table 32. BSDS and Active Logs - Storage Group Volumes
SMS STORAGE GROUP VOLUMES
SGDB2PLG RV1CU1
RV2CU1
RV3CU1
RV2CU3
RV3CU3
SGDBACTL RV1CU3
RV2CU2
/*********************************************/
/* MANAGEMENT CLASS */
/* FILTLIST DEFINITIONS */
/*********************************************/
FILTLIST ACTLOG INCLUDE(DB2*.BSDS*.**,
DB2*.LOGCOPY*.DS*)
/*********************************************/
/* SELECTION ROUTINE FOR BSDS & ACTIVE LOGS */
/*********************************************/
IF &DSN EQ &ACTLOG
THEN DO
SET &MGMTCLAS = 'MCDBACTL'
EXIT
END