Filter
Top Products
General Information 21
Network Boot Prompt
This option allows the user to boot from the Network
by pressing F12 after the system is turned on.
Pressing F12 will override the normal boot sequence.
Select “Enabled“ to display the F12 prompt.
Power-On Status
This option controls the display of the memory count,
system check points, and beeps when the system is
turned on. Select “Enabled” to allow this information
to be displayed. Select “Disabled“ which is the
default value to turn these off.
Virus Detection
The system has a built-in virus detection program.
The virus detection program runs at boot time, and
can be enabled or disabled from this field. The
default is set to “Disabled“.
Date and Time
From the Configuration/Setup main menu, select the
Date and Time option to view or change the system
clock from the Date and Time menu. If you want to
change the system date, enter the date in the format
shown on the screen.
If you change the time, enter the time in 24-hour
format (hours, minutes, seconds). For example:
- 12 midnight is 00:00:00
- 12 noon is 12:00:00
- 1 p.m. is 13:00:00
When setting date and time, press the up- or down-
arrow key to highlight a field. The date and time are
saved as you type it.
System Security
Enhanced Security Enabled/Disabled
Enhanced Security can be Enabled or Disabled only
while flashing the system BIOS. Enhanced Security
Enabled gives the highest level of protection of
system resources by locking the Administrator
password and startup sequence in the EEPROM.
This level of security may not be desirable in
networking environment.