Filter
Top Products
56 IBM Desktop System HMM
NOTE: If you cannot access the hard disk drive or
load a CD from the CD-ROM drive, make sure
that the BIOS Setup Utility has the startup
sequence set with CD ROM and hard disk
drives.
001 - START
•
Insert the diagnostics program CD into the CD-
ROM drive.
•
Power-off then power-on the system unit.
002 - DO ANY POST MESSAGES, ERROR
CODES, BEEPS, OR SYMPTOMS OCCUR? (YES,
READ AHEAD. NO, GO TO STEP 003)
•
Go to “Index of Symptoms, Messages, Error
Codes, or Beeps” on page 36.
•
End.
003 -
•
Select Utility from the menu.
•
Select and execute Tech Support Form from the
menu to generate a system configuration report.
•
Compare the system configuration list with the
actual devices installed in system.
NOTE: If necessary, remove the cover and visually
compare the devices installed in the system
unit to those shown in the Tech Support Form.
004 - IF THE NUMBER OF HARD DISK OR CD-
ROM DRIVE IS NOT CORRECT, READ AHEAD; OR
GO TO STEP 005.
•
Check the cable installation of all disk drives.
(See “System Board Jumpers and Connectors” on
page 105)
- IDE Primary Channel Master and Slave Drives
should be connected to the system board con-
nector CN8.
- IDE Secondary Channel Master and Slave
Drives should be connected to the system board
connector CN7.