Filter
Top Products
92 Hardware Maintenance Manual: xSeries 250
∼1∼ Media-bay bezel
To install the media-bay bezel:
1. Insert the two tabs on the top of the media-bay bezel into the matching holes on
the server chassis.
2. Push the bottom of the media-bay bezel toward the server until the two tabs at the
bottom of the bezel snap into place.
Installing the top cover
∼1∼ Top cover
∼2∼ Captive screws
To install the server top cover:
1. Before installing the cover, check that all cables, adapters, and other components
are installed and seated correctly and that you have not left loose tools or parts
inside the server.
2. Lower the cover with the rear edge of the cover about 25 mm (1 inch) back from
the rear edge of the server.
3. Slide the cover forward.
4. Tighten the two captive screws on the back edge of the cover.
5. If you disconnected any cables from the back of the server, reconnect the cables;
then, plug the power cords into properly grounded electrical outlets.
Note: If necessary, see “Cabling the server” on page 104 for connector locations.
1
1
2