IBM 8000 Series Network Card User Manual


 
3ware Escalade ATA RAID Controller Installation Guide
22
www.3ware.com
Figure 3. Parallel ATA Drive with Serial ATA
Converter Installed
Check your installation and close the case
1 After all of the drives are connected to the ATA RAID Controller
and it is installed in its slot, verify that the cables do not interfere
with the operation of any other components in the case or block
the flow of cooling air.
2 Close the case and reconnect the power cables.
Check motherboard boot sequence
Using your computer’s Setup utility, ensure that your boot device
precedes the Escalade ATA RAID Controller in the boot sequence.
If you have other disks installed on the motherboard, the ATA
RAID Controller precedes them in boot order.
CBL-P-SATA (Parallel to Serial Converter)