Filter
Top Products
DO YOU WANT TO TEST AN INTERFACE (V.24, V.35, OR X.21)?
Note: You can test the PCI co-processor adapter with or without the
37-pin wrap plug (shown in “Cables and Wrap Plugs” on
page 4-23). The wrap plug lets you test the electrical
interfaces.
NO Press 9; then press Enter and go to page 4-10.
YES Press one of the following numbers (displayed in the Ports
column):
0 to test the V.24 interface
1 to test the V.35 interface.
2 to test the X.21 interface.
Continue on page 4-14.
Questions will be displayed on your screen. Answer the questions
and respond to the prompts.
If you are instructed to remove the cable and connect a wrap plug to
the card, be sure you connect the interface co-processor wrap plug
to the co-processor adapter being tested.
Note: The cable wrap plug connects to the cable only.
Do the following if you receive an error code:
1. Record the co-processor adapter card address.
2. Record the error code.
3. See page 4-12.
Otherwise, upon completion of the interface test, continue on the
next page.
When the tests have completed for the interface being tested, the
message at the bottom of the following screen is displayed.
4-14
X.25 Co-Processor PCI GTO