Filter
Top Products
USER RESPONSIBLE FOR VERIFYING VERSION AND COMPLETENESS
OEM FUNCTIONAL SPECIFICATION ULTRASTAR XP (DFHC) SSA MODELS 1.12/2.25 GB - 1.0" HIGH
2.2.2 C2x Models
The following voltage specifications apply at the drive power connector. There is no special power on/off
sequencing required. The extra power needed for Brick On Sled models and the +38V power option are
described in 2.2.4, “CxB Models” on page 33.
Input Voltage
+ 5 Volts Supply 5V (± 5% during run and spin-up)
+ 12 Volts Supply 12V (± 5% during run) (+ 5% / -7% during spin-up)
The following current values are the combination measured values of SCSI models and SSA Cx4 model. The
differences between SCSI and SSA is +5V currents. Because of different interface electronics and speed, SSA
electronics card requires more +5V current than SCSI. Read/Write Base Line is 290 ma higher. Idle
Average is 500 ma higher. (290ma and 500ma differences were found by measuring SSA Cx4 model). SSA
+5 V current numbers are derived from SCSI +5 V current numbers by adding 290ma and 500ma accord-
ingly.
Population Population
Power Supply Current Notes Mean Stand. Dev.
+5VDC (power-up) Minimum voltage slew rate = 4.5 V/sec
+5VDC (idle avg) 1.23 Amps 0.02 Amps
+5VDC (R/W baseline) 1.25 Amps
4
0.05 Amps
+5VDC (R/W pulse) Base-to-peak .36 Amps 0.06 Amps
+12VDC (power-up) Minimum voltage slew rate = 7.4 V/sec
+12VDC (idle avg) 0.41 Amps 0.02 Amps
+12VDC (seek avg) 1 op/sec 0.0031 Amps 0.0002 Amps
+12VDC (seek peak) 1.20 Amps
5
0.02 Amps
+12VDC (spin-up) 4.2 sec max 1.5 Amps
6
0.1 Amps
Drive power
Avg idle power 11.07 Watts .35 Watts
Avg R/W power 30 ops/sec 12.25 Watts .35 Watts
4
See Figure 4 on page 24 for a plot of how the read/write baseline and read/write pulse sum together.
5
The idle average and seek peek should be added together to determine the total 12 volt peak current. See Figure 5
on page 25 for a typical buildup of these currents. Refer to examples on the following page to see how to combine
these values.
6
The current at start is the total 12 volt current required (ie. the motor start current, module current and voice coil
retract current). See Figure 6 on page 26 for typical 12 volt current during spindle motor start.
Source filename=POWER IBM Corporation Page 21 of 87