Filter
Top Products
EasyCoder 3400e Bar Code Label Printer User’s Manual
6-12
8. Press the Feed/Pause button.
The printer prints out the software configuration label. Verify that the label states
the correct mode.
9. Turn the printer off and then on.
10. Download the 86XX formats, fonts, and graphics from the host to the printer.
Using Forms Adjust
If your label prints too close to one edge, you can reposition it by using the X Forms
Adjust and Y Forms Adjust features. The X forms adjust controls the position of the
printing area along the length of the label. The Y forms adjust controls the position of
the printing area along the width of the label.
The following figure shows the default X and Y origins. You can control the default X
origin (top of form) with the PrintSet software or with the Test and Service DIP
switches. You can control the default Y origin with the DIP switches only.
*FORMAT*
*FORMAT*
3XXXU.049
➤
➤
-X
Y
➤
+X
+Y
➤
Direction of media from printer
Origin (Ø,Ø)
Leading
Edge