Filter
Top Products
Installing memory
Installing a firmware
card
Installing an option card
1
Unpack the memory option.
2
Open both latches on the connector.
3
Push the memory card firmly into the connector until it snaps
into place.
1
Locate the holes on the system board near the option card
connectors.
2
Unpack the firmware card.
3
Holding the firmware card by its sides, align the two pins on the
card with the holes on the system board.
4
Push in until the firmware card is firmly in place.
1
Locate the card connectors on the system board. If you are
installing only one card, install it in connector 1.
2
Locate the two screws on the back of the printer that attach the
metal plate to the slot.
3
Remove and save the two screws, and then remove and
discard the plate.
4
Unpack the card.
5
Align the connection points on the card with the connector on
the system board and push the card firmly into the system
board connector.
Assemble paper handling options
15