Filter
Top Products
225
CHAPTER 16 INSTRUCTION SET
Clock Flag
Note 1 Note 2
ZACCY
saddr.bit, $addr16 3 8 9 PC ← PC + 3 + jdisp8 if(saddr.bit) = 1
sfr.bit, $addr16 4 – 11 PC ← PC + 4 + jdisp8 if sfr.bit = 1
BT A.bit, $addr16 3 8 – PC ← PC + 3 + jdisp8 if A.bit = 1
PSW.bit, $addr16 3 – 9 PC ← PC + 3 + jdisp8 if PSW.bit = 1
[HL].bit, $addr16 3 10 11 PC ← PC + 3 + jdisp8 if (HL).bit = 1
saddr.bit, $addr16 4 10 11 PC ← PC + 4 + jdisp8 if(saddr.bit) = 0
sfr.bit, $addr16 4 – 11 PC ← PC + 4 + jdisp8 if sfr.bit = 0
BF A.bit, $addr16 3 8 – PC ← PC + 3 + jdisp8 if A.bit = 0
PSW.bit, $addr16 4 – 11 PC ← PC + 4 + jdisp8 if PSW. bit = 0
[HL].bit, $addr16 3 10 11 PC ← PC + 3 + jdisp8 if (HL).bit = 0
PC ← PC + 4 + jdisp8
saddr.bit, $addr16 4 10 12 if(saddr.bit) = 1
then reset(saddr.bit)
PC ← PC + 4 + jdisp8 if sfr.bit = 1
then reset sfr.bit
BTCLR PC ← PC + 3 + jdisp8 if A.bit = 1
then reset A.bit
PC ← PC + 4 + jdisp8 if PSW.bit = 1
then reset PSW.bit
PC ← PC + 3 + jdisp8 if (HL).bit = 1
then reset (HL).bit
B ← B – 1, then
PC ← PC + 2 + jdisp8 if B ≠ 0
C ← C –1, then
PC ← PC + 2 + jdisp8 if C ≠ 0
(saddr) ← (saddr) – 1, then
PC ← PC + 3 + jdisp8 if(saddr) ≠ 0
SEL RBn 2 4 – RBS1, 0 ← n
NOP 1 2 – No Operation
EI 2 – 6 IE ← 1(Enable Interrupt)
DI 2 – 6 IE ← 0(Disable Interrupt)
HALT 2 6 – Set HALT Mode
STOP 2 6 – Set STOP Mode
Notes 1. When the internal high-speed RAM area is accessed or instruction with no data access
2. When an area except the internal high-speed RAM area is accessed
Remark One instruction clock cycle is one cycle of the CPU clock (f
CPU) selected by the PCC register.
Mnemonic Operands Byte Operation
Instruction
Group
CPU
control
Condi-
tional
branch
sfr.bit, $addr16 4 – 12
A.bit, $addr16 3 8 –
PSW.bit, $addr16 4 – 12 ×××
[HL].bit, $addr16 3 10
12
B, $addr16 2 6 –
DBNZ C, $addr16 2 6 –
saddr. $addr16 3 8 10