Filter
Top Products
120 Geac System21 commerce.connect: Implementation on the iSeries Server
Figure 5-13 WRKSYSSTS display showing the memory pool names
As in the other images, shared pool 2 was used. It is not appearing as the last system
pool. That’s because the system was restarted since the configuration change was made,
and during the following start, QSYSWRK started before QINTER.
22.Check the QSQSRVR jobs by using the following command:
WRKACTJOB JOB(QSQSRVR)
23.On the Work with Active Jobs display (Figure 5-14), you may need to press F14 to see the
jobs, since at this stage, they may all be waiting. Press F11 to see the Pool column. The
QSQSRVR jobs should be using the new pool. Note that the number will not be 2 as
specified in step 9 through step 11 on page 117, but the system pool number as noted in
step 21. If the new pool is not being used, check that you followed step 9 through step 11
on page 117 correctly.
In this example, the QSQSRVR jobs use pool 3, which matches the system pool for
*SHRPOOL2 in Figure 5-13. Therefore, the QSQSRVR jobs use shared pool 2.
Figure 5-14 WRKACTJOB display showing the pool numbers for the QSQSRVR jobs
24.Start the WebSphere subsystem:
STRSBS SBSD(QEJB/QEJBSBS)
Notice that this starts the default instance of WebSphere.
25.Check the QEJBSBS subsystem:
WRKACTJOB SBS(QEJBSBS)