Filter
Top Products
48
Replacing the projection lamp
The lamp hours used timer in the Projector Info menu counts the number of hours
the lamp has been in use. Twenty hours before the lamp life expires, the message
“Change lamp” appears on the screen at startup.
• NOTE:
You can order new lamps from www.infocus.com (in select areas),
your retailer or your dealer. Only genuine InFocus lamps are tested for use in
this projector. InFocus is not liable for the performance, safety or certification
of any other lamps. The use of other lamps violates the projector warranty and
voids all certification marks on this projector.
WARNINGS:
• To avoid burns, allow the projector to cool
for at least 60 minutes before you
replace the lamp.
• Only genuine InFocus lamps are tested with
this projector. Use of other lamps
may cause electrical shock and fire.
• Unplug the power cord before replacing the lamp.
• Do not drop the lamp module. The glass
may shatter and cause injury.
• Do not touch the glass lamp screen. Fingerpr
ints can obscure projection
sharpness.
• Be extremely careful when removing the lamp housing. In the unlikely event
that the lamp ruptures, small glass fragments may be generated. The lamp
module is designed to contain most of these fragments, but use caution when
removing it. Before replacing a ruptured lamp, clean the lamp compartment
and dispose of cleaning materials. Wash hands after lamp replacement.
Hg – Lamp contains mercury. Manage in a
ccordance with local disposal laws.
See www.lamprecycle.org.
Lamp hours
®
multimedia
turn off and unplug
projector
wait 60 minutes