InFocus network adapter Network Card User Manual


 
24 InFocus LiteShow User’s Guide
Resetting your LiteShow
To reset your LiteShow to the original factory settings, do the following:
1 Remove the LiteShow module from the projector.
2 Grasp the module in both hands. Press firmly on the ribbed portion of the clear plastic top to disengage the locking
tab. The tab is located on the back of the module. Then pull the top off of the module.
3 Pull the card out of the slot. Make sure to pull it straight out so you do not bend the connecting pins inside the
module.
Remove the LiteShow module
Remove the top
Remove the card