Filter
Top Products
Receive and Transmit Description
38 Software Developer’s Manual
3.3.3.1 Transmit Descriptor Command Field Format
The CMD byte stores the applicable command and has fields shown in Table 3-10.
Table 3-10. Transmit Command (TDESC.CMD) Layout
7 6 5 4 3 2 1 0
IDE VLE DEXT
RSV
RPS
a
a. 82544GC/EI only.
RS IC IFCS EOP
TDESC.CMD Description
IDE (bit 7)
Interrupt Delay Enable
When set, activates the transmit interrupt delay timer. The Ethernet controller loads
a countdown register when it writes back a transmit descriptor that has RS and IDE
set. The value loaded comes from the IDV field of the Interrupt Delay (TIDV)
register. When the count reaches 0, a transmit interrupt occurs if transmit descriptor
write-back interrupts (IMS.TXDW) are enabled. Hardware always loads the transmit
interrupt counter whenever it processes a descriptor with IDE set even if it is
already counting down due to a previous descriptor. If hardware encounters a
descriptor that has RS set, but not IDE, it generates an interrupt immediately after
writing back the descriptor. The interrupt delay timer is cleared.
VLE (bit 6)
VLAN Packet Enable
When set, indicates that the packet is a VLAN packet and the Ethernet controller
should add the VLAN Ethertype and an 802.1q VLAN tag to the packet. The
Ethertype field comes from the VET register and the VLAN tag comes from the
special field of the TX descriptor. The hardware inserts the FCS/CRC field in that
case.
When cleared, the Ethernet controller sends a generic Ethernet packet. The IFCS
controls the insertion of the FCS field in that case.
In order to have this capability CTRL.VME bit should also be set, otherwise VLE
capability is ignored. VLE is valid only when EOP is set.
DEXT (bit 5)
Extension (0b for legacy mode).
Should be written with 0b for future compatibility.
RPS
RSV (bit 4)
Report Packet Sent
When set, the 82544GC/EI defers writing the DD bit in the status byte
(DESC.STATUS) until the packet has been sent, or transmission results in an error
such as excessive collisions. It is used is cases where the software must know that
the packet has been sent, and not just loaded to the transmit FIFO. The 82544GC/
EI might continue to prefetch data from descriptors logically after the one with RPS
set, but does not advance the descriptor head pointer or write back any other
descriptor until it sent the packet with the RPS set. RPS is valid only when EOP is
set.
This bit is reserved and should be programmed to 0b for all Ethernet controllers
except the 82544GC/EI.
RS (bit 3)
Report Status
When set, the Ethernet controller needs to report the status information. This ability
may be used by software that does in-memory checks of the transmit descriptors to
determine which ones are done and packets have been buffered in the transmit
FIFO. Software does it by looking at the descriptor status byte and checking the
Descriptor Done (DD) bit.