Filter
Top Products
Using the Setup Program
61
APM Submenu
To access this menu, select Power on the menu bar, then APM.
Maintenance Main Advanced Security
Power
Boot Exit
APM
ACPI
Table 25 shows the options available for setting the APM features.
Table 25. APM Submenu
Feature Options Description
Power Management • Disabled
• Enabled (default)
Enables or disables the APM feature.
Inactivity Timer • Off
• 1 Minute
• 5 Minutes
• 10 Minutes
• 20 Minutes (default)
• 30 Minutes
• 60 Minutes
• 120 Minutes
Specifies the amount of time before the computer enters
APM standby mode.
Hard Drive • Disabled
• Enabled (default)
Enables power management for hard disks during APM
standby mode.
ACPI Submenu
To access this menu, select Power on the menu bar, then ACPI.
Maintenance Main Advanced Security
Power
Boot Exit
APM
ACPI
The submenu represented in Table 26 is for setting the ACPI features.
Table 26. ACPI Submenu
Feature Options Description
ACPI Suspend State
• S1 State (default)
• S3 State
Specifies the ACPI sleep state.
The wake jumper must be set to wake from PS/2 device
or USB device under S3 state.
Video Repost
(This feature is present
only when ACPI Suspend
State is set to S3)
• Disabled (default)
• Enabled
Allows the video BIOS to be initialized coming out of the
S3 state. Some video controllers require this option to
be enabled. This feature is present only if the ACPI
suspend state is set to S3 state. See page 35 for more
information on how to set the jumper blocks.
Wake on LAN from S5
• Stay Off (default)
• Power On
In ACPI soft-off mode only, determines how the system
responds to a LAN wake up event when the system is in
the ACPI soft-off mode.