Filter
Top Products
Intel
®
Q965 Express Chipset
October 2007 DM
Order Number: 315664-002US 34
Setting Up & Configuring the Development Kit—Intel Q965 Express Chipset
3. Check for damage that may have occurred during shipment. Contact your sales
representative if any items are missing or damaged.
Caution: Connecting the wrong cable or reversing the cable can damage the evaluation board
and may damage the device being connected. Since the board is not in a protective
chassis, use caution when connecting cables to this product.
Caution: Standby voltage is constantly applied to the board. Therefore, do not insert or remove
any hardware unless the system is unplugged.
Note: The evaluation board is a μBTX form factor. A μBTX chassis may be used if a protected
environment is desired.
4. Check the jumper settings (refer to Chapter 3.0). Jumper J6LB is used to clear the
CMOS memory. Make sure this jumper is set for normal operation.
5. Insert the processor (enclosed in the kit is Intel
®
Core™2 Duo processor E6400)
into the LGA775 socket
6. Attach the BTX Thermal Module Assembly (TMA) over the processor to the Support
and Retention Module (SRM) by following procedures described below.
7. Place the uBTX board on the Support and Retention Module (SRM) so that the holes
A, B, C and D on the PCB line up with the corresponding locations on the SRM (see
Figure 6).
Figure 6. Align the Development Kit Board and SRM
A
B
C
D
A
B
C
D
BTX Board
SRM