Filter
Top Products
Intel Q965 Express Chipset—Setting Up & Configuring the Development Kit
Intel
®
Q965 Express Chipset
DM October 2007
39 Order Number: 315664-002US
Tighten the screws at the rear end of the heatsink as shown in the figure below.
Note: Please make sure all the screws are tightened before using the system.
8. Plug the processor heat sink fan into J3TH.
9. Connect the SATA drive through SATA cable into J24LB (SATA 0). Connect a power
cable to the SATA drive.
10. (Optional) Plug the floppy disk drive through the ribbon cable into J4LH. Connect a
power cable to the floppy drive.
11. Insert the two DDR2 memory (enclosed in the kit are two 512 Mbyte DDR2 667MHz
unbuffered DIMMs) into slots J1MY and J3MY. Optional to insert DDR2 memory into
slots J2MY and J4MY.
12. Insert a USB CD or DVD into one of the USB ports (J17LB) at the back panel.
Optional to plug a SATA CD or DVD into J22LB.
13. Connect a PS/2 Keyboard into J5LH (purple connector) at the back panel. Optional
to connect a USB keyboard into J17LB.
14. Connect a PS/2 Mouse into J5LH (green connector) or a USB Mouse into one of the
USB ports (J17LB) at the back panel.
15. Optional to connect a PCI Express x16 graphics card into J6UB. Optional to install a
MEC card into J6UB.
16. Plug the front panel header cable into J28LB.
17. Plug the monitor into the VGA connector J4UB or Plug the monitor into the add in
graphics card’s video connector.
18. Optional to connect the audio speakers to J4AU and J5AU (Please refer to
Chapter 2.0 for details).
Figure 11. Secure the read end of heatsink to the SRM