Filter
Top Products
Board Manual 29
Intel® IQ80219 General Purpose PCI Processor Evaluation Platform
Getting Started
2.6.5 ARM Extended Debugger
For further information on the AXD Debugger, refer to the content of the ARM ADS. This setup
assumes that Angel is Flashed on the board:
Description: Terminal emulator runs on host and communicates with the board via the serial cable.
Start: Power up the target board. After the ‘reset’ is asserted, the two 7-segment LEDs
display blank. The time for reset is approximately 1 or 2 seconds.
Assumptions: ARM Developer Suite (ADS) is loaded to Win32 Host, Angel is Flashed to ROM,
Host com port is connected to board serial port ## and compiled project file
Worchester.mcp
1
exists.
Following are the steps from setup to running a project file that has been previously created and
named Worchester.mcp:
1. From Windows start menu:
a. Programs -> ARM Developer Suite v1.1 -> Metrowerks CodeWarrior
2. From CodeWarrior open project and start debugger:
a. File -> Open (All files) -> Worchester.mcp
b. Project -> Enable Debugger
c. Project -> Debug (AXD Interface comes up)
3. From AXD (ARM extended debugger) configure and connect:
a. Connect Host to Target with serial cable
Options -> Configure Target … -> Set Target Environment = ADP
Select Configure
Select… , ARM Serial Driver, OK
Endian: Little
Configure… , Serial Port:= COM1, Baud Rate:=115200, OK, OK, OK
b. Load Image and Start
On AXD menu: File -> Load Image… -> File name: Cyclone.axf -> Open ->
c. Execute -> Select Go, Breakpoints
4. The LEDs now Flashes ‘80219’. You can set breakpoints and step to control speed or stop
location.
1. To be supplied separately.