Filter
Top Products
66 Board Manual
Intel® IQ80219 General Purpose PCI Processor Evaluation Platform
Hardware Reference Section
3.10.9.19 Jumper J1G2
3.10.9.20 Jumper J3E1
3.10.9.21 Jumper J3G1
Initialization Device Select:
Used as a chip select during configuration read and write transactions on the secondary bus.
Applications that do not require access to the bridge configuration registers from the
secondary bus pull this pin low.
Table 76. Jumper J1G2: Descriptions
Jumper Association Description Factory Default
J1G2 PPCI-X Reset
Can isolated the PCI-X reset from getting to the
board.
2-3
Table 77. Jumper J1G2: Settings and Operation Mode
J1G2 Operation Mode
Pins 1,2 P_RST (primary side reset) disconnected from reset circuitry.
Pins 2,3 P_RST (primary side reset) used to reset board.
Table 78. Jumper J3E1: Descriptions
Jumper Association Description Factory Default
J3E1 SPCI-X Clock Enables spread-spectrum on the SPCI-X clock. 2-3
Table 79. Jumper J3E1: Settings and Operation Mode
J3E1 Operation Mode
Pins 1,2
Spread-spectrum enabled.
Pins 2,3
Spread-spectrum disabled.
Table 80. Jumper J3G1: Descriptions
Jumper Association Description Factory Default
J3G1 PCI-X Bridge S_IDSEL: Enables Bridge access from the SPCI-X side. 2-3
Table 81. Jumper J3G1: Settings and Operation Mode
J3G1 Operation Mode
Pins 1,2
Uses S_IDSEL as chip select during configuration read and write transactions on the
secondary bus.
Pins 2,3
S_IDSEL is pulled down for application that do not require access to bridge configuration
registers from secondary bus.