Intel NuPRO-850 Switch User Manual


 
Introduction 9
DDR DIMM timing register, which provides the DIMM speed control for the
entire array, must be programmed to use the timings of the slowest DIMMs
installed. Note: DIMMs must be populated in identical pairs for dual-channel
operation
BIOS
: Award / Phoenix BIOS advanced by ADLINK
NuPRO-850 supports BIOS memory size up to 8Mbytes (Firmware Hub
I/F).
Flash write protection will be implemented under software control. This bit
must be set to 1 before any write will be allowed to the BIOS Flash.
Gigabit Ethernet
One 10/100/1000Mbps Ethernet interfaces via the Intel® 82547GI Gigabit
Ethernet Controller. The 82547GI is connected to the CSA
(Communicating Streaming Architecture) interface of the 82875P MCH.
Support 1000Base-T, 100Base-TX and 10Base-T (IEEE 802.3, 802.3u,
and 802.3ab).
IEEE802.3x compliant flow control, support auto-negotiation and link
setup.
Ethernet link status and activity LEDs on the RJ-45 connector.
Graphic Display
ATI Mobility M9 (AGP4X) or M10 (AGP8X) VGA chip with 64MB video
memory.
Standard SVGA CRT analog output on bracket I/O panel.
Also supports 2
nd
CRT output (via one onboard 14-pin header) and one
LVDS interface.
USB Interface
Supports four USB 2.0 ports, two connectors (USB0 & USB1) on bracket
and the others (USB2 & USB3) are routed to one onboard 9-pin header
IDE Ports
Two IDE connectors support up to four drivers. Up to Ultra DMA 100
Mode.
Super I/O and WDT
Built-in HanceRapids, support 2-stage WDT, programmable timer 1 - 255
seconds or 1 - 255 minutes.