Filter
Top Products
Getting Started • 27
To install either types of module, follow these procedures:
Figure 6: Inserting DIMM into Socket
1. Align the module to the socket so that the edge connectors on the
module match the socket sections.
2. Hold the module perpendicular to the motherboard and press the
edge connector into the socket.
3. Press the module fully into the socket so that the socket retaining
arms swing up and engage the retention notches at each end of the
module.
4. Following the configuration chosen, repeat for all other modules (if
any).
5. Once the modules are installed, system memory installation is
complete.
3.3 Connecting IDE Devices to the NuPRO-850
The NuPRO-850 supports two IDE channels, Primary and Secondary. It has
two IDE device connectors onboard supporting IDE devices running in any
data transfer mode up to ATA-100. Each IDE connector supports two drives, a
Master and a Slave. The drives connect to the NuPRO-850 with an IDE ribbon
cable.
To install an IDE drive, connect the drive to one of the drive connectors to a
suitable ribbon cable. Plug the board end of the cable into one of the IDE
connectors on the NuPRO-850. Make sure pin 1 of the ribbon cable connector
is aligned with pin 1 of the IDE device connector.