Filter
Top Products
Getting Started • 25
3
Getting Started
This chapter gives a summary of what is required to setup an operational
system using the NuPRO-850, including hardware installation and an overview
of the BIOS.
3.1 CPU Installation
The NuPRO-850 CPU module supports single/dual FC-mPGA2 Intel®
Pentium® 4 processor with a front side bus (FSB) of 800MHz or 533MHz.
Users need to install highly efficient CPU fan/cooler to guarantee the systems
stability.
To install the CPU follow the steps below carefully:
1. Lift the lever on the CPU socket.
2. Insert the CPU in the socket, making sure that pin 1 of the CPU aligns
with pin 1 of the socket (both corners are marked with a triangle)
3. Press the lever down until you hear it “click” into the locked position.
4.
Apply the proper amount of thermal compound to the CPU die and
place the heatsink and fan on top of the CPU.
5. Connect the three wires of the CPU fan to the respective CPU fan
connector.
Note: Ensure that the CPU heat sink and the CPU top surface are in
tight contact to avoid CPU overheating problem that would
cause your system to hang or crash. The CPU heat sink and fan
should be installed tightly together. Please contact ADLINK
dealers for suitable heat sink and fan assemblies