Filter
Top Products
32 • Driver Installation
4.1.2 Hardware Configuration File Installation
This section describes how to install the hardware configuration files into a
system operating Windows 2000/XP.
1. Check the System Requirements. Windows 2000/XP must be fully
installed and running on the system prior to running this software.
2. Close any running applications.
3. The files are stored in an integrated application setup program. This
program is designed for a Windows 2000/XP and can be executed from
the
Run
command prompt.
4. Place the ADLINK CD into the CD-ROM drive. Run Setup.exe under
X:\NuPRO\NuPRO-850\chipset. Where X is the CD drive letter.
5. The user will be prompted with a license agreement. Should the user not
agree with the terms and conditions for using the software, the Installer will
exit before extracting any files.
6. Follow the on-screen instructions and use the default settings to complete
the setup, once the operating system has rebooted. This completes the
installation of the Intel® Chipset Software Installation Utility.
4.2 Driver Installation
4.2.1 VGA Driver Installation
Windows 2000/XP will attempt to install a standard VGA driver automatically.
To guarantee compatibility, manually install the most updated VGA driver,
which is stored in the ADLINK CD. After installing Windows 2000/XP, update to
the most updated driver by following these steps:
1. Boot Windows 2000/XP, then run the program
\NuPRO\NuPRO-850\VGA\SETUP.EXE
2. The VGA driver will automatically be installed onto the system.
3. Restart the system.