Filter
Top Products
Evaluation Platform Board Manual 21
Intel
®
IQ80332 I/O Processor
Getting Started
2.6.4 GNUPro GDB/Insight
2.6.4.1 Communicating with RedBoot
Hardware Setup:
• Host with UNIX/Linux or Win32 installed
• IQ80332 with serial cable
• RedHat RedBoot monitor Flashed to the platform board
Recommended Mapping of UART Ports to Host Com Ports
• Host port connected to the platform board UART.
The following communication tools can be used:
• Win32 using HyperTerminal
• UNIX using Kermit
• Linux using Minicom
• Solaris using Tip
RedBoot Monitor startup:
Description: terminal emulator runs on host and communicates with the board via the serial cable.
Start: Power up the IQ80332. While the 'reset' is asserted, the two 7-segment LEDs sequentially
display “88”, “A0” through “A6”, followed by “SL” (Scrub loop). When RedBoot is
successfully booted, it displays the characters “A1” on the LEDs. When the final state of “A1”
does not occur, reset the processor again.
The time for reset is approximately 1 or 2 seconds.
Win32 on Host Connecting with HyperTerminal.