Filter
Top Products
PX865PE7 PRO/ PX865PE7
30
IDE Primary / Secondary /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives in your
stem. As well, your operating environment requires a DMA driver (Windows 95 OSR2 or a third
IDE bus master driver). If your hard drive and your system software both support Ultra DMA
00, select “Auto” to enable BIOS support. Options: Auto (default)、Disabled
**OnChip Serial ATA Setting***
n-Chip Serial ATA
his item allows you to enable or disabled the on-chip serial ATA function.
ptions:
isabled Disable on-chip serial ATA. No Serial ATA devices installed.
uto(default) BIOS will auto-detect the presence of any SATA devices. When attach
4 (or 3) IDE drivers + 2 (or 1) SATA drivers Æ Enhanced Mode
2 (or 1) IDE drivers + 2 (or 1) SATA drivers Æ Combined Mode
2 (or 1)SATA drivers Æ SATA only
4 (or3, or 2, or 1) IDE drivers Æ Disabled
ombined Mode Windows
®
98/ME can recognize IDE devices but cannot directly recognize
A device and therefore you must use this mode to allow the SATA
nnel can support 2 IDE drives). If you
ll all 4 IDE drives and both SATA drives, you will only see 2 of
rives along with the 2 IDE drives in this mode.
de, you can use all 6 hard disk drives (including 4 IDE drives and
you install SATA drives only.
d Device” label and then press the enter key, it will take you to a
sy
party
1
*
O
T
O
D
A
C
an SAT
device to simulate an IDE device by assuming the role of one IDE channel
in the system. This means that you will have one available IDE channel for
2 SATA drives to use (each IDE cha
were to insta
dthe SATA
Enhanced Mode In this mo
2 SATA drives). Note: You cannot use “Enhanced” mode with Windows
®
98/ME. It only support to install Windows
®
2000/ XP if you want to boot
from SATA device. (It’s restriction from Microsoft.)
SATA Only Select this option when
Serial ATA Port0/ 1 Mode
This item allows you to select the Serial ATA device mode for port 0 & 1 .
Onboard Device
If you highlight the “Onboar
submenu with the following options:
USB Controller
This option should be enabled if your system has a USB port installed on the system board. You will
need to disable this feature if you add a higher performance controller.
Options: Enabled (default)、Disabled