Filter
Top Products
PX865PE7 PRO/ PX865PE7
31
USB 2.0 Controller
This option should be enabled if your system has a USB 2.0 device installed on the system board.
You will need to disable this feature if you install a USB 1.1 device.
Options: Enabled (default)、Disabled
USB Keyboard Support
Enables support for USB attached keyboards. Options: Disabled (default)、Enabled
lows you to control the onboard AC’97 audio. Options: Enabled (default)、Disabled
field ill d i ng power after a power failure. If
sys
select “Former-Sts”, the
Options: Off (default)、
Power On Func
This option allows you
g
KB Power On P
This it the password tha
key) to power on your
Hot Key”.
Ctrl-F12
y disk controller (FDC) installed on the system board and
install an add-in FDC or the system has no floppy drive, select “Disabled”.
elect an address and corresponding interrupt for the first/ second serial port.
AC97 Audio
This item al
Onboard LAN Device (only for PX865PE7 PRO)
This item allows you to enable or disable the LAN Device. Options: Enabled (default)、Disabled
Onboard I/O Chip Setup
PWRON After PWR-Fail
This w eterm ne whether your system will boot after restori
you select “On”, the tem will boot whether or not the system was on before power failure. If you
system will be restored to the status before the power failure.
On、Former-Sts
tion
to select a way to power on your computer. Options: Password、Hot KEY、
ht Any KEY BUTTON ONLY (default), and Keyboard 9Mouse Left、Mouse Ri 、 、 8
assword
t your system will use as part of the power-on sequence. This field is only
configurable when “Power On Function” is set to “Password”.
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function
system. This field is only configurable when “Power On Function” is set to “
Options: Ctrl-F1、Ctrl-F2……
Onboard FDC Controller
ystem has a floppSelect “Enabled” if your s
you wish to use it. If you
Options: Enabled (default)、Disabled
t 2 Onboard Serial Port 1/ Por
S