Filter
Top Products
3-4 IQ80960RM/RN
Evaluation Board Manual
Hardware Reference
3.4 Console Serial Port
The console serial port on the IQ80960RM/RN platform, based on a 16C550 UART, is capable of
operation from 300 to 115,200 bps. The port is connected to a phone jack-style plug on the
IQ80960RM/RN platform. The DB25 to RJ-45 cable included with the IQ80960RM/RN can be
used to connect the console port to any standard RS-232 port on the host system.
The UART on the IQ80960RM/RN platform is clocked with a 1.843 MHz clock, and may be
programmed to use this clock with its internal baud rate counters. The UART register addresses are
shown in Table 3-5; refer to the 16C550 device data book for a detailed description of the registers
and device operation. Note that some UART addresses refer to different registers depending on
whether a read or a write is being performed.
3.5 Secondary PCI Bus Expansion Connectors
Four PCI Expansion Slots are available on the IQ80960RM/RN platform. The IQ80960RM
supports 32-bit PCI expansion and the IQ80960RN supports 64-bit PCI expansion. The slots are
designed for +5V PCI signalling and accommodate PCI cards with +5V or universal signalling
capabilities.
3.5.1 PCI Slots Power Availability
Power from the Primary PCI bus, +3.3V, +5V, +12V, and –12V, is routed to the Secondary PCI bus
expansion slots. +3.3V is only available at the secondary PCI slots if the host system makes +3.3V
available on the Primary PCI slots. LED CR5 indicates if this power is available.
Table 3-5. UART Register Addresses
Address Read Register Write Register
E000 0000H Receive Holding Register Transmit Holding Register
E000 0001H Unused Interrupt Enable Register
E000 0002H Interrupt Status Register FIFO Control Register
E000 0003H Unused Line Control Register
E000 0014H Unused Modem Control Register
E000 0015H Line Status Register Unused
E000 0016H Modem Status Register Unused
E000 0017H Scratchpad Register Scratchpad Register