Filter
Top Products
Table 23. Primary/Secondary IDE Master/Slave Submenus (continued)
Feature Options Description
PIO Mode
(Note)
(This feature is present
only when Type is not
set to Auto.)
• Auto (default)
• Mode 0
• Mode 1
• Mode 2
• Mode 3
• Mode 4
Specifies the PIO mode.
Ultra DMA
(This feature is present
only when Type is not
set to Auto.)
• Disabled (default)
• Mode 0
• Mode 1
• Mode 2
• Mode 3
• Mode 4
• Mode 5
Specifies the Ultra DMA mode for the drive.
Cable Detected
(Note)
No options Displays the type of cable connected to the IDE
interface: 40-conductor or 80-conductor
(for ATA-66/100 devices).
Note: These configuration options appear only if an IDE device is installed.
Diskette Configuration Submenu
To access this menu, select Advanced on the menu bar, then Diskette Configuration.
Maintenance Main
Advanced
Security Power Boot Exit
PCI Configuration
Boot Configuration
Peripheral Configuration
IDE Configuration
Diskette Configuration
Event Log Configuration
The submenu represented by Table 24 is used for configuring the diskette drive.
Table 24. Diskette Configuration Submenu
Feature Options Description
Diskette Controller
• Disabled
• Enabled (default)
Disables or enables the integrated diskette
controller.
Floppy A
• Not Installed
• 360 KB 5¼"
• 1.2 MB 5¼"
• 720 KB 3½"
• 1.44/1.25 MB 3½" (default)
• 2.88 MB 3½"
Specifies the capacity and physical size of
diskette drive A.
continued
Configuration Software and Utilities 71