Filter
Top Products
Intel Server Board SE7501CW2 Installation and Integration Guide
Installing the Processor Wind Tunnel
The following instructions apply to the base Intel Server Chassis SC5200 and reference
chassis installations. Direct the airflow from the processor wind tunnel toward the rear of
the chassis as shown.
Attaching the Heat Sink Fan
Install the processor wind tunnel center section over the
heat sink. The plastic tabs on the wind tunnel center
section must engage the tabs on the retention
mechanism. Make sure the fan’s sticker is facing away
from the assembly, so that the airflow is into the
assembly.
Attaching the Fan/Intake Assembly
1. Position the fan/intake assembly at approximately 45°,
and engage the clip at the top of the tunnel as shown.
2. Gently squeeze the two tabs on the assembly, and
insert them into the two mating slots on the wind
tunnel.
3. Rotate the fan/intake downward to engage the mating
clips on the wind tunnel.
14