Filter
Top Products
Intel
®
Server System SR1680MV Service Guide 33
Note: Before you remove or install the power supply, complete the following steps:
1. Make sure the server is not turned on or connected to the AC power. To power off
the server, see “Power Off”.
2. Remove the motherboard cage module. To remove the cover, see “Removing the
Server Board Cage Module”.
3. Disconnect all necessary cable connections.
Removing an HDD Backplane
1. Loosen the two securing screws on the backplane.
2. Lift the backplane up from motherboard.
Figure 38. Remove the Screws and Lift the Backplane Up
Installing a 2.5-inch Pluggable SATA HDD Backplane
Reverse the “Removing an HDD Backplane” steps to install the 2.5-inch pluggable SATA
HDD backplane.
System Fans
Each I/O board cage module includes three system fans. The six system fans on the server
system share the same removal and installation procedures. For your reference, this
section provides the steps for replacing one system fan on the right I/O board cage module
as an example.
The following figure shows the location of the system fan on the right I/O board cage
module: