Filter
Top Products
harDware
Front Panel (compressed view)
Rear Panel (compressed view)
inStallation/SetuP
Digital KVM over IP Switch Setup
1. Plug the included power adapter into the switch and an AC source,
then turn on the switch.
2. Set up your local console by connecting a keyboard, monitor and
mouse to the corresponding Console (keyboard, video and mouse)
ports on the switch (see Rear Panel above). Refer to Appendix A in
the user manual for an introduction to basic local console operation.
3. Connect to one or more computers/servers as described below. Refer
to Appendix B in the user manual for samples of connector cables,
including the recommended Combo-Free USB PS/2 KVM Cable.
NOTE: Make sure that any PS/2 computers are turned off before
4
Port-switching buttons (8-port model shown)
Link
Video
10/100
Selected
Live
Bank no.
Power
Serial port 2 (serial power control/external
modem support)
Serial port 1
(console mgmt.)
Restore-to-default
button
Power adapter jack
Ethernet port PC ports (8-port model shown)
Daisy chain out
Local console ports: keyboard, video, mouse