Filter
Top Products
5
Installation
1. Connect the router to your ADSL cable through the supplied RJ11 cable.
2. Connect the router to your PC, hub or switch by attaching the Ethernet cable
to the LAN port of the router.
3. Connect the power adapter to the power jack on the rear panel of the router.
4. The ADSL LED will be on if the router is connected to the ADSL cable and
receives the ADSL signals successfully. If the LED is blinking, contact your
ISP (Internet service provider) to check the problem.
NOTE: Use only the power adapter included with the router, and not any other
power adapter.