Filter
Top Products
56
clients. If you enable this function, set the MAC address
of the wireless clients that you want to filter.
Disable disables this function.
Allow Listed only allows the wireless clients with the MAC
address you have specified access to the router.
Deny Listed means the wireless clients with the MAC
address you have specified will be denied access to the
router.
MAC Address
Enter the MAC address of the wireless clients for the
filtering control.
Current Access Control
List
To remove a MAC address from the Current Access
Control List, select it and click “Delete Selected.” To
remove all MAC addresses from the table, just click
“Delete All.” Click “Reset” to clear your current selections.
When you finish, click “Apply Changes.” You’ll see the following message
displayed on Web browser.
Click “Continue” to save the settings made and go back to the Web management
interface; click “Apply” to save the settings made and restart the router so the
settings will take effect after it reboots.
5.2.4.5 WPS
Although home Wi-Fi networks have become more and more popular, users still
have trouble with the initial setup of a network. This obstacle forces users to use
an open security setting and increases the risk of eavesdropping. Wi-Fi Protected
Setup (WPS) was designed to make it easier to set up security-enabled Wi-Fi
networks and, subsequently, network management.
The biggest difference between WPS-enabled devices and legacy devices is that
users do not need to know about SSID or channel and security settings, but they
could still surf in a security-enabled Wi-Fi Network. This device supports both the
Push Button and PIN methods for WPS, as described below.