Filter
Top Products
14
Installation
Guide
Verify that the jumper on your CD drive is set
to “Master.”
In order for the CD drive and Zip
®
drive to work together properly, ensure
that the jumper on the CD drive is set to the “master” setting. A chart
indicating the jumper setting should be located on the CD drive. If you are
unsure of the setting or how to change it, refer to the documentation that
came with your CD drive or computer.
Connect the CD drive and the Zip
®
Internal
drive to the motherboard.
Using the 40-pin IDE interface cable that is provided, connect the long
end, or the end furthest from the middle connector on the cable, to the
secondary IDE channel. Connect the middle connector to the CD drive
and then connect the other end of the cable to the Zip
®
Internal drive.
CAUTION Make sure PIN 1 on the cable connects to PIN 1 on the
Zip
®
Internal drive, the CD drive and the motherboard. All IDE
interface cable connections must maintain correct PIN 1 orientation
in order for the Zip
®
drive to be recognized by the system. ˾
PIN 1
Zip Internal drive
PIN 1
40-pin Interface Cable Connector
Stripe on Interface Cable indicates PIN 1
The IDE interface cable can be connected from the secondary IDE channel
to the CD drive and then to the Zip
®
drive, or it can be connected from the
secondary IDE channel to the Zip drive and then to the CD drive. For
information on possible IDE/ATAPI drive configurations for your
computer, see Understanding IDE Connections on pages 36 and 37.
6
7