Filter
Top Products
15
Installation
Guide
Connect an internal computer power supply
cable to the Zip
®
drive.
˾ NOTE: If the computer does not have a spare power supply
cable, use the power Y-cable provided. Disconnect the power from
the CD drive or another device (do not disconnect the power to the
hard drive) and connect the power Y-cable. Connect the two
extensions of the power Y-cable to both the CD drive or other device
and to the Zip
®
Internal drive. ˾
Zip Internal
drive
Power Supply Cable
from Computer
CAUTION Make sure the power supply cable is securely connected to
the Zip
®
drive. ˾
Secure drive in drive bay.
Align the front of the Zip
®
drive with other drives installed in the computer.
If there is not clear access to the drive bay mounting holes, refer to your
computer manual for additional instructions. Note that if the drive is held
in place securely by rails, you will not need to use the mounting screws.
Drive Bay
Mounting Screws
CAUTION Mounting screws must not extend into the Zip
®
Internal
drive farther than 4.0 mm (about 0.16 inch). Mounting screws that
are too long could damage the drive. ˾
8
9