Filter
Top Products
SSG 20 Hardware Installation and Configuration Guide
40 Basic Wireless Configuration
5. Activate wireless changes.
Wireless > General Settings > Click Activate Changes.
CLI
1. Set the WLAN country code and IP address.
set wlan country-code {code_id}
set interface wireless_interface ip ip_addr/netmask
2. Set the SSID.
set ssid name name_str
set ssid name_str authentication auth_type encryption encryption_type
set ssid name_str interface interface
(optional) set ssid name_str key-id number
3. Set the WLAN mode.
set interface wireless_interface wlan both
4. Activate wireless changes.
save
exec wlan reactivate
You can set an SSID to operate in the same subnet as the wired subnet. This action
allows clients to work in either interface without having to reconnect in another
subnet.
To set an Ethernet and a wireless interface to the same bridge-group interface, use
the WebUI or CLI as follows:
WebUI
Network > Interfaces > List > Edit (bgroup_name) > Bind Port: Select the
wireless and ethernet interfaces, then click Apply.
CLI
set interface bgroup_name port wireless_interface
set interface bgroup_name port ethernet_interface
NOTE:
Bgroup_name can be bgroup0—bgroup3.
Ethernet_interface can be ethernet0/0—ethernet0/4.
Wireless_interface can be wireless0/0—wireless0/3.
If a wireless interface is configured, then you need to reactivate the WLAN with
the exec wlan reactivate CLI command or click Activate Changes on the Wireless
> General Settings WebUI page.