Filter
Top Products
24
DLA-M5000CLE (Re)/ LCT0979-002A / ENGLISH
Basic Operations
■
Projector’s buttons
■
Remote control unit
The following describes the basic procedure for normal use
of the projector.
1. Turning on the Power
1
Turn on the MAIN POWER switch of the
projector.
2
Press the OPERATE button for one second
or more.
(Or press the remote control’s OPERATE
button for one second or more.)
• The OPERATE indicator comes on.
• About 30 seconds after the MAIN POWER switch is
turned on, you can start projecting.
Note
• After the power is turned on, the screen may be jumbled for
a few seconds, but this is not a malfunction.
■
Turning off the Power
1
Press the OPERATE button for one second
or more.
(Or press the remote control’s OPERATE
button for one second or more.)
• The STAND BY indicator changes to blinking, and the
projector goes into cool-down mode.
2
Turn off the MAIN POWER switch after the
cooling fans have stopped running.
* Do not turn off the MAIN POWER switch during cool
down mode (the STAND BY indicator blinking). About
10 minutes after the STAND BY indicator comes on
steady (stand-by mode), the cooling fans (except the
one for the light-source lamp power supply) will stop,
and then turn off the MAIN POWER switch.
■
Caution on extended projection:
When projection continues for an extended amount of
time, be sure to allow the lamp to be turned off for at
least two minutes for every 72 hours of continued
projection.
If you do otherwise, the service life of the lamp may be
severely affected.
STAND BY
OPERATE
LAMP
EMERGENCY
AV
RGB
TEMP
STAND BY indicator
OPERATE indicator
OPERATE button
2
,
1
MAIN POWER switch
1
,
2
OPERATE button
2
,
1
M
E
N
U
/
E
N
T
E
R
QUICK
ALIGN.
AV HIDE
OPERATE
PRESET
AV
SHIFT ZOOM FOCUS
LENS
UT
+
DW
–
RGB/COMPUTER
LENS
LOCK UNLOCK
PAGE BACK
ON [ ❙ ]: The main power turns on and the STAND BY
indicator comes on.
OFF [‡
‡‡
‡]:The MAIN POWER switch turns off and the
STAND BY indicator goes off.
Projector’s indicator
STAND BY
OPERATE
OPERATE
Remote control unit
Projector
or
STAND BY
Example of the
projector’s button
OPERATE
\
Projector
STAND BY
Projector
DLA-M5000LE&SCE Eng Re.book Page 24 Tuesday, March 12, 2002 3:59 PM