Filter
Top Products
10
Menu Configuration—MAIN MENU
PICTURE IMPROVEMENT
Setting for the picture quality
Item To do Setting value
APERTURE*
Select the frequency of the luminance signal compensated in
“APERTURE LEVEL.”
OFF, LOW, HIGH
APERTURE
LEVEL*
Compensate the frequency response of the luminance signal of the
video signal.
01 – 10
sub menu
Display the sub menu which enables you to adjust the items of “PICTURE IMPROVEMENT” while
viewing the actual picture.
reset
Restore the default settings for all the items in “PICTURE IMPROVEMENT.”
BACK LIGHT
Adjusts the brightness of the display.
• When the DYNAMIC lamp lights, this item does not appear on the menu (☞ 8 on page 6).
FOCUS ASSIST
Helps to focus the picture.
• When “ON” is selected,
– “PICTURE IMPROVEMENT” is not displayed on the menu.
– The settings of “PICTURE IMPROVEMENT” are ineffective.
COLOR RANGE MODE
Reduces the difference of the luminance level specific to the LCD panel.
• When “ON” is selected, the color temperature becomes the innate temperature in the LCD panel, and the
setting of “WHITE BALANCE SET.” becomes ineffective (☞ page 14).
VIDEO/COMPO. SEL.
Selects the signal type you want to use for the VIDEO/COMPONENT terminals.
• When select the component (COMPO.), make sure to set the component level in “COMPO. LEVEL” in
“PICTURE SUB ADJ.” (☞ page 14).
ASPECT*
Changes the aspect ratio of the picture.
* Memorized for each input — composite signal input (VIDEO), component signal input (COMPO.), SDI 1 and SDI 2.
For the operation procedure, see page 7.
• The menu automatically disappears in about 30 seconds after the previous operation.
• Some items may not appear on the menu depending on the input or the input signal.
• The items controlled by the MAKE system do not appear on the menu.
Setting value: –20 – +20
Setting value: OFF, ON
Operation guide
Shows the buttons for
each operation.
Setting value: VIDEO, COMPO. (component)
Setting value: 4:3, 16:9
Setting value: OFF, ON
DT-V9L3D_J_en.indb 10DT-V9L3D_J_en.indb 10 09.8.7 1:30:31 PM09.8.7 1:30:31 PM